Re: 1997 Dodge Ram Question

[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]

Posted by rhouston on June 30, 2004 at 13:34:17 from (65.161.97.25):

In Reply to: 1997 Dodge Ram Question posted by The Rodent on June 28, 2004 at 16:34:45:

97 1500 SLT club cab 4x4 5.2l (318)

front breaks every 40K (inboard pad smaller than outboard squeely tab is on outboard -duh)
front axle u joints every 40-50K
Front wheel bearings aroung 120K
Fuel pump at 120K
oil pump at 120K
water pump at 120K
whole engine at 150K (not Dodge's fault)
driver door rust through at bottom at 160K
all front tie rods, drag link, antisway bar mounts replaced by 160K
both oxygen sensors aroung 160K

American made my tail
I just did the front brakes last week end using aftermarket parts

Calipers made in Canada
rotors made in China
drivers side wheel bearing ($125) made in Japan
brake pads made in good ol U.S.A.

Follow Ups:

Re: Re: 1997 Dodge Ram Question 26Red 14:16:58 07/07/04 (0)

Post a Followup

Name:
E-Mail: Hide: Yes No
Hiding your address protects you from spam generators but allows you to receive email response notifications.
Subject: Re: Re: 1997 Dodge Ram Question
Comments:

Optional Link URL:
Link Title:
Optional Image URL:

Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

[Home]