Re: Camshaft

[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]

Posted by wrenchman on June 25, 2002 at 22:48:56 from (216.76.200.214):

In Reply to: Camshaft posted by TBrake on June 24, 2002 at 19:42:18:

it should work fine if it's a manual tranny.your idle will get a bit lopey though...you might look into replacing the valvesprings too as the early 360's had low pressure ones...BTW,the early 360's were built on 340 cores & have a .040 smaller bore with a longer stroke.it is possible to bore .040 over & use stock 340 pistons & they can be bored .080 over safely...most 360's had cast cranks & shouldn't be wound past 5000rpm's...

Follow Ups:

Post A Followup

Name:
E-Mail:
Subject: Re: Re: Camshaft
Comments:

Optional Link URL:
Link Title:
Optional Image URL:

Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

[Home]