Removing drive train from a 48 panel

[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]

Posted by Mike on May 24, 2006 at 19:29:28 from (70.70.192.100):

We were about to remove the motor,trany and drive shaft. It seems the drive shaft is a soild tube into the rear end . Question can you remove the motor and transmission as a unit and get by the cross member?
Or do you have to pull the motor and than take the trany out through the floor? Or even better pull the rear end back to seperate it from the trany. The manuel I have does not tell you these fun questions.
Any help would be great help.Also the drive train is forsale.The motor was rebuilt and it is a four speed Transmission.I live in B.C Canada.

Follow Ups:

Re: Removing drive train from a 48 panel Billy 19:51:30 05/24/06 (0)

Post A Followup

Name:
E-Mail:
Subject: Re: Removing drive train from a 48 panel
Comments:

Optional Link URL:
Link Title:
Optional Image URL:

Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

[Home]