Re: Re: HELP flat head ford runs hot??

[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]

Posted by dave guest on September 07, 2006 at 10:17:06 from (4.229.117.48):

In Reply to: Re: HELP flat head ford runs hot?? posted by Dan on September 06, 2006 at 18:24:41:

If you are on 12 volt, you need a resistor in the sending switch circuit to get the needle to read where you want it. Make sure you are not overheating first. Buy a little pocket thermometer and check the coolant temp with cap off. It will run hotter this way because of no pressure. If boils then you engine is overheating. Remove cap before starting so you don't get burned. BTDT. It hurts and embarasses.

Follow Ups:

Post A Followup

Name:
E-Mail:
Subject: Re: Re: Re: HELP flat head ford runs hot??
Comments:

Optional Link URL:
Link Title:
Optional Image URL:

Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

[Home]