Re: '55 F-600 6Vto12V Revisited-Jon Hagan

[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]

Posted by Jon Hagen on December 03, 2006 at 07:31:14 from (69.26.29.3):

In Reply to: '55 F-600 6Vto12V Revisited-Jon Hagan posted by Michael Sheik on December 03, 2006 at 06:56:49:

Thats the CVR. The CVR case/mount tab must be connected to a good electrical ground or it will not function. You are correct that IGN terminal is 12V in from the ignition switch,and the unmarked terminal is the common power feed for all the 6V guages. I have always tested them with the guage load connected and should indicate 6-8V at the unmarked terminal. You may need an old analog needle type volt meter to test it,the voltage is a bit lumpy and a digital volt meter may have a bit of a hard time reading that.

Follow Ups:

Re: Re: '55 F-600 6Vto12V Revisited-Jon Hagan Michael Sheik 12:31:53 12/03/06 (2)
- Re: Re: Re: '55 F-600 6Vto12V Revisited-Jon Hagan Jon Hagen 16:02:55 12/03/06 (1)
  - Re: Re: Re: Re: '55 F-600 6Vto12V Revisited-Jon Ha Michael Sheik 17:23:04 12/03/06 (0)
Re: Re: '55 F-600 6Vto12V Revisited-Jon Hagan Bob 10:42:59 12/03/06 (0)

Post A Followup

Name:
E-Mail:
Subject: Re: Re: '55 F-600 6Vto12V Revisited-Jon Hagan
Comments:

Optional Link URL:
Link Title:
Optional Image URL:

Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

[Home]