Re: 1961 Ford Unibody

[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]

Posted by Tim K on February 23, 2007 at 11:22:15 from (156.144.107.21):

In Reply to: 1961 Ford Unibody posted by regan on February 23, 2007 at 09:08:42:

If you have a choice to lenthen or shorten, it's a no brainer. Shorten the drive shaft. To lengthen will take a tube diameter to match, 2 welding paths, and critical alignment setup on the welding jig or lathe. Shorten it and you can make an exact cut on the lathe, tack weld it in place on the lathe, finish up with one weld pass, and balance.

Follow Ups:

Post A Followup

Name:
E-Mail:
Subject: Re: Re: 1961 Ford Unibody
Comments:

Optional Link URL:
Link Title:
Optional Image URL:

Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

[Home]