1975 Heavy Half

[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]

Posted by Jasone on September 27, 2002 at 06:15:00 from (12.33.196.233):

Have a 350 engine question. I just installed a factory rebuilt quadrajet to replace the O.E. one. Old carb had a float problem and I couldn't fix it. I checked oil before firing it up and noticed gasoline in the oil. I added some oil and fired the truck to see if it would actually start with the new carb. It did, and I let it run for about 2 minutes. I shut it down and checked oil again and "seems" as though I have even more gas in the oil!! Are my rings that bad? Is the fuel pump diaphram leaking? A stuck valve? I think I am going to drain pan and put new oil in and see if I get more gas in the pan before anything, cause I think that the gas origanally got there from the stuck float valve on old carb. - but I am open to suggestions. Thanks.....

Follow Ups:

Re: 1975 Heavy Half Andy in Ohio 19:26:56 09/28/02 (0)
Re: 1975 Heavy Half John Ne. 10:14:13 09/27/02 (1)
- Re: Re: 1975 Heavy Half Jason 18:24:50 09/28/02 (0)

Post A Followup

Name:
E-Mail:
Subject: Re: 1975 Heavy Half
Comments:

Optional Link URL:
Link Title:
Optional Image URL:

Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

[Home]