Re: 671 Detroit Clutch problem

Posted by Jon Hagen on September 28, 2009 at 21:26:29 from (70.41.64.58):

In Reply to: Re: 671 Detroit Clutch problem posted by Billy Ky on September 28, 2009 at 19:57:21:

Name: Jon Hagen (Reserved Name)
E-Mail:
Subject: Re: 671 Detroit Clutch problem
In Reply to: Re: 671 Detroit Clutch problem posted by Billy Ky on September 28, 2009 at 19:57:21:
Body of Message:

Two problems causing no clutch release on 6-71 that I have seen ,
1 wrong disc for the flywheel or pressure plate, ( if the splined hub is too large diameter or too long so it rubs on the flywheel or prerssure plate, it will cause a no release condition.)

2 If the trans was plugged into the clutch disc and allowed to sag before piloting into the bellhousing, the disc may have been bent so the disc still contacts the released pressure plate and flywheel. One contact point on the flywheel side and another 180 degrees opposite on the pressure plate.

Replies:

Add a Reply Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Optional Video Title: Optional Video URL: Advanced Posting Options Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.   Advanced Posting Tools   Upload Photo  Select Gallery Photo  Return to Post