Re: Eaton 2-speed question

[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]

Posted by wrench 309 on February 03, 2003 at 17:57:47 from (64.255.99.103):

In Reply to: Eaton 2-speed question posted by poorerbut on February 03, 2003 at 11:35:46:

go with the silicon on the cleaned axle to hub mating surface in the old days axle bearing where packed with grease and the rubber was to keep gear lube in the axle tube, but with todays wheel seal quality run bears in gear lube pevides for longer bearing life and better lubercation.

Follow Ups:

Post A Followup

Name:
E-Mail:
Subject: Re: Re: Eaton 2-speed question
Comments:

Optional Link URL:
Link Title:
Optional Image URL:

Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

[Home]