Re: block heater blew out of the block!!

[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]

Posted by Jon Kraatz on April 07, 2002 at 00:04:45 from (208.190.249.140):

In Reply to: block heater blew out of the block!! posted by Andy on April 06, 2002 at 17:47:11:

If your block heater is made like most it has a rubber ring around the outside to seal it in a frost plug hole in the side of the engine block. If this is the type of heater you have, the bolt you see in the center of it is what tightens it up in the block when you put it back in. Tightening the screw down expands the rubber ring and seals it back in the block. As long as the seal is still intact, putting it back in and re tightening the bolt should have you back good as new.

Follow Ups:

Re: Re: block heater blew out of the block!! John Ne. 08:53:20 04/07/02 (0)

Post A Followup

Name:
E-Mail:
Subject: Re: Re: block heater blew out of the block!!
Comments:

Optional Link URL:
Link Title:
Optional Image URL:

Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

[Home]