[an error occurred while processing this directive]

'79 Ford Courier front disk spacer

[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]

Posted by Slowpoke on February 05, 2004 at 00:00:55 from (67.30.100.112):

Hi, all... I removed the front disk to clean and grease the bearings at 175K. On the spindle is a spacer about 1/4" thick that sits at the backing plate and the grease seal rides on the outer rim of the spacer. The spacer is free to rotate on the spindle and I think the seal may be pulling it around as there is some noticeable wear.
Is the spacer supposed to rotate or do I need to stop it someway? Should the inner race of the bearing be holding it from moving when the bearings are adjusted correctly??
Thanks for any ideas.

Follow Ups:




Post A Followup

Name:
E-Mail:

Subject: Re: '79 Ford Courier front disk spacer

Comments:

Optional Link URL:
Link Title:
Optional Image URL:

Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

[an error occurred while processing this directive]